AU_LINUX_ANDROID_ICS.04.00.04.00.126 from msm-3.0.
First parent is from google/android-3.4.
* commit 'AU_LINUX_ANDROID_ICS.04.00.04.00.126': (8712 commits)
PRNG: Device tree entry for qrng device.
vidc:1080p: Set video core timeout value for Thumbnail mode
msm: sps: improve the debugging support in SPS driver
board-8064 msm: Overlap secure and non secure video firmware heaps.
msm: clock: Add handoff ops for 7x30 and copper XO clocks
msm_fb: display: Wait for external vsync before DTV IOMMU unmap
msm: Fix ciruclar dependency in debug UART settings
msm: gdsc: Add GDSC regulator driver for msm-copper
defconfig: Enable Mobicore Driver.
mobicore: Add mobicore driver.
mobicore: rename variable to lower case.
mobicore: rename folder.
mobicore: add makefiles
mobicore: initial import of kernel driver
ASoC: msm: Add SLIMBUS_2_RX CPU DAI
board-8064-gpio: Update FUNC for EPM SPI CS
msm_fb: display: Remove chicken bit config during video playback
mmc: msm_sdcc: enable the sanitize capability
msm-fb: display: lm2 writeback support on mpq platfroms
msm_fb: display: Disable LVDS phy & pll during panel off
...
Signed-off-by: Steve Muckle <smuckle@codeaurora.org>
Store the context id in the register trace buffer.
The process id can be derived from the context id.
This gives a general idea about what process was last
running when the RTB stopped.
Change-Id: I2fb8934d008b8cf3666f1df2652846c15faca776
Signed-off-by: Laura Abbott <lauraa@codeaurora.org>
This patch introduces a new Kconfig option which, when enabled, causes
the kernel to write the PID of the current task into the PROCID field
of the CONTEXTIDR on context switch. This is useful when analysing
hardware trace, since writes to this register can be configured to emit
an event into the trace stream.
The thread notifier for writing the PID is deliberately kept separate
from the ASID code, so that we can easily support newer processors (A15
onwards) which store the ASID in TTBR0. As such, the switch_mm code is
updated to perform a read-modify-write sequence to ensure that we don't
clobber the PID on older CPUs.
Change-Id: I7236834cf4b5e984c9d9f24ba6b872078c2b936f
Cc: Wolfgang Betz <wolfgang.betz@st.com>
Signed-off-by: Will Deacon <will.deacon@arm.com>
Signed-off-by: Jeff Ohlstein <johlstei@codeaurora.org>
With LPAE, TTBRx registers are 64-bit. The ASID is stored in TTBR0
rather than a separate Context ID register. This patch makes the
necessary changes to handle context switching on LPAE.
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
Annotate the low level hardware locks which must not be preempted.
In mainline this change documents the low level nature of
the lock - otherwise there's no functional difference. Lockdep
and Sparse checking will work as usual.
Change-Id: I1c73fd5472b9ab356173637a7819095394004ebf
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
Cc: Russell King <rmk+kernel@arm.linux.org.uk>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
[kumarrav@codeaurora.org: fixup gic.c and cache-l2x0.c merge conflict]
Signed-off-by: Ravi Kumar <kumarrav@codeaurora.org>
Annotate the low level hardware locks which must not be preempted.
In mainline this change documents the low level nature of
the lock - otherwise there's no functional difference. Lockdep
and Sparse checking will work as usual.
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
Cc: Russell King <rmk+kernel@arm.linux.org.uk>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
This reverts commit 45b95235b0.
Will Deacon reports that:
In 52af9c6c ("ARM: 6943/1: mm: use TTBR1 instead of reserved context ID")
I updated the ASID rollover code to use only the kernel page tables
whilst updating the ASID.
Unfortunately, the code to restore the user page tables was part of a
later patch which isn't yet in mainline, so this leaves the code
quite broken.
We're also in the process of eliminating __ARCH_WANT_INTERRUPTS_ON_CTXSW
from ARM, so lets revert these until we can properly sort out what we're
doing with the context switching.
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
This reverts commit 52af9c6cd8.
Will Deacon reports that:
In 52af9c6c ("ARM: 6943/1: mm: use TTBR1 instead of reserved context ID")
I updated the ASID rollover code to use only the kernel page tables
whilst updating the ASID.
Unfortunately, the code to restore the user page tables was part of a
later patch which isn't yet in mainline, so this leaves the code
quite broken.
We're also in the process of eliminating __ARCH_WANT_INTERRUPTS_ON_CTXSW
from ARM, so lets revert these until we can properly sort out what we're
doing with the ARM context switching.
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
Now that ASID 0 is no longer used as a reserved value, allow it to be
allocated to tasks.
Acked-by: Catalin Marinas <catalin.marinas@arm.com>
Signed-off-by: Will Deacon <will.deacon@arm.com>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
On ARMv7 CPUs that cache first level page table entries (like the
Cortex-A15), using a reserved ASID while changing the TTBR or flushing
the TLB is unsafe.
This is because the CPU may cache the first level entry as the result of
a speculative memory access while the reserved ASID is assigned. After
the process owning the page tables dies, the memory will be reallocated
and may be written with junk values which can be interpreted as global,
valid PTEs by the processor. This will result in the TLB being populated
with bogus global entries.
This patch avoids the use of a reserved context ID in the v7 switch_mm
and ASID rollover code by temporarily using the swapper_pg_dir pointed
at by TTBR1, which contains only global entries that are not tagged
with ASIDs.
Acked-by: Catalin Marinas <catalin.marinas@arm.com>
Signed-off-by: Will Deacon <will.deacon@arm.com>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
The current ASID allocation algorithm doesn't ensure the notification
of the other CPUs when the ASID rolls over. This may lead to two
processes using the same ASID (but different generation) or multiple
threads of the same process using different ASIDs.
This patch adds the broadcasting of the ASID rollover event to the
other CPUs. To avoid a race on multiple CPUs modifying "cpu_last_asid"
during the handling of the broadcast, the ASID numbering now starts at
"smp_processor_id() + 1". At rollover, the cpu_last_asid will be set
to NR_CPUS.
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
Errata 411920 indicates that any "invalidate entire instruction cache"
operation can fail if the right conditions are present. This is not
limited just to those operations in flush.c, but elsewhere. Place the
workaround in the already existing __flush_icache_all() function
instead.
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
Makes code futureproof against the impending change to mm->cpu_vm_mask.
It's also a chance to use the new cpumask_ ops which take a pointer
(the older ones are deprecated, but there's no hurry for arch code).
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
ARMv7 can have VIPT, PIPT or ASID-tagged VIVT I-cache. This patch
adds the necessary invalidation of the I-cache when the ASID numbers
are re-used.
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
Close a hole in the ASID version switch, particularly the following
scenario:
CPU0 MM PID CPU1 MM PID
idle
A pid(A)
A idle(lazy tlb)
* new asid version triggered by B *
B pid(B)
A pid(A)
* MM A gets new asid version *
A idle(lazy tlb)
A pid(A)
* CPU1 doesn't see the new ASID *
The result is that CPU1 continues running with the hardware set
for the original (stale) ASID value, but mm->context.id contains
the new ASID value. The result is that the next MM fault on CPU1
updates the page table entries, but flush_tlb_page() fails due to
wrong ASID.
There is a related case with a threaded application is allocated
a new ASID on one CPU while another of its threads is running on
some different CPU. This scenario is not fixed by this commit.
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
On newer architectures (ARMv6, ARMv7), the depth of the prefetch and
branch prediction is implementation defined and there is a small risk
of wrong ASID tagging when changing TTBR0 before setting the new
context id. The recommended solution is to set a reserved ASID during
TTBR changing. This patch reserves ASID 0.
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
Rename mmu.c to context.c - it's the ARMv6 ASID context handling
code rather than generic "mmu" handling code.
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
Kevin F. Haggerty
Francescodario Cuzzocrea
Steve Muckle
Laura Abbott
Will Deacon
Catalin Marinas
Thomas Gleixner
Russell King
Rusty Russell
Russell King