To optimize "rep ins" instruction do IO in big chunks ahead of time
instead of doing it only when required during instruction emulation.
Signed-off-by: Gleb Natapov <gleb@redhat.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
Currently when string instruction is only partially complete we go back
to a guest mode, guest tries to reexecute instruction and exits again
and at this point emulation continues. Avoid all of this by restarting
instruction without going back to a guest mode, but return to a guest
mode each 1024 iterations to allow interrupt injection. Pending
exception causes immediate guest entry too.
Signed-off-by: Gleb Natapov <gleb@redhat.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
c->eip is never written back in case of emulation failure, so no need to
set it to old value.
Signed-off-by: Gleb Natapov <gleb@redhat.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
Currently emulation is done outside of emulator so things like doing
ins/outs to/from mmio are broken it also makes it hard (if not impossible)
to implement single stepping in the future. The implementation in this
patch is not efficient since it exits to userspace for each IO while
previous implementation did 'ins' in batches. Further patch that
implements pio in string read ahead address this problem.
Signed-off-by: Gleb Natapov <gleb@redhat.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
in/out emulation is broken now. The breakage is different depending
on where IO device resides. If it is in userspace emulator reports
emulation failure since it incorrectly interprets kvm_emulate_pio()
return value. If IO device is in the kernel emulation of 'in' will do
nothing since kvm_emulate_pio() stores result directly into vcpu
registers, so emulator will overwrite result of emulation during
commit of shadowed register.
Signed-off-by: Gleb Natapov <gleb@redhat.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
Add decoding of X,Y parameters from Intel SDM which are used by string
instruction to specify source and destination. Use this new decoding
to implement movs, cmps, stos, lods in a generic way.
Signed-off-by: Gleb Natapov <gleb@redhat.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
All struct operand fields are initialized during decoding for all
operand types except OP_MEM, but there is no reason for that. Move
OP_MEM operand initialization into decoding stage for consistency.
Signed-off-by: Gleb Natapov <gleb@redhat.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
When x86_emulate_insn() does not know how to emulate instruction it
exits via cannot_emulate label in all cases except when emulating
grp3. Fix that.
Signed-off-by: Gleb Natapov <gleb@redhat.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
If LOCK prefix is used dest arg should be memory, otherwise instruction
should generate #UD.
Signed-off-by: Gleb Natapov <gleb@redhat.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
Return X86EMUL_PROPAGATE_FAULT is fault was injected. Also inject #UD
for those instruction when appropriate.
Signed-off-by: Gleb Natapov <gleb@redhat.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
Resent spec says that for 0f (20|21|22|23) the 2 bits in the mod field
are ignored. Interestingly enough older spec says that 11 is only valid
encoding.
Signed-off-by: Gleb Natapov <gleb@redhat.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
Eliminate the need to call back into KVM to get it from emulator.
Signed-off-by: Gleb Natapov <gleb@redhat.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
Use this callback instead of directly call kvm function. Also rename
realmode_(set|get)_cr to emulator_(set|get)_cr since function has nothing
to do with real mode.
Signed-off-by: Gleb Natapov <gleb@redhat.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
Make use of bool as return values, and remove some useless
bool value converting. Thanks Avi to point this out.
Signed-off-by: Gui Jianfeng <guijianfeng@cn.fujitsu.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
Mov reg, cr instruction doesn't change flags in any meaningful way, so
no need to update rflags after instruction execution.
Signed-off-by: Gleb Natapov <gleb@redhat.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
Check return value against correct define instead of open code
the value.
Signed-off-by: Gleb Natapov <gleb@redhat.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
During rep emulation access length to RCX depends on current address
mode.
Signed-off-by: Gleb Natapov <gleb@redhat.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
Commit fb341f57 removed the pte prefetch on guest invlpg, citing guest races.
However, the SDM is adamant that prefetch is allowed:
"The processor may create entries in paging-structure caches for
translations required for prefetches and for accesses that are a
result of speculative execution that would never actually occur
in the executed code path."
And, in fact, there was a race in the prefetch code: we picked up the pte
without the mmu lock held, so an older invlpg could install the pte over
a newer invlpg.
Reinstate the prefetch logic, but this time note whether another invlpg has
executed using a counter. If a race occured, do not install the pte.
Signed-off-by: Avi Kivity <avi@redhat.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
The update_pte() path currently uses a nontrapping spte when a nonpresent
(or nonaccessed) gpte is written. This is fine since at present it is only
used on sync pages. However, on an unsync page this will cause an endless
fault loop as the guest is under no obligation to invlpg a gpte that
transitions from nonpresent to present.
Needed for the next patch which reinstates update_pte() on invlpg.
Signed-off-by: Avi Kivity <avi@redhat.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
Currently emulated atomic operations are immediately followed by a non-atomic
operation, so that kvm_mmu_pte_write() can be invoked. This updates the mmu
but undoes the whole point of doing things atomically.
Fix by only performing the atomic operation and the mmu update, and avoiding
the non-atomic write.
Signed-off-by: Avi Kivity <avi@redhat.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
Once upon a time, locked operations were emulated while holding the mmu mutex.
Since mmu pages were write protected, it was safe to emulate the writes in
a non-atomic manner, since there could be no other writer, either in the
guest or in the kernel.
These days emulation takes place without holding the mmu spinlock, so the
write could be preempted by an unshadowing event, which exposes the page
to writes by the guest. This may cause corruption of guest page tables.
Fix by using an atomic cmpxchg for these operations.
Signed-off-by: Avi Kivity <avi@redhat.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
kvm_mmu_pte_write() reads guest ptes in two different occasions, both to
allow a 32-bit pae guest to update a pte with 4-byte writes. Consolidate
these into a single read, which also allows us to consolidate another read
from an invlpg speculating a gpte into the shadow page table.
Signed-off-by: Avi Kivity <avi@redhat.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
If no irq chip in kernel, ioctl KVM_IRQ_LINE will return -EFAULT.
But I see in other place such as KVM_[GET|SET]IRQCHIP, -ENXIO is
return. So this patch used -ENXIO instead of -EFAULT.
Signed-off-by: Wei Yongjun <yjwei@cn.fujitsu.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
If no irq chip in kernel, ioctl KVM_IRQ_LINE will return -EFAULT.
But I see in other place such as KVM_[GET|SET]IRQCHIP, -ENXIO is
return. So this patch used -ENXIO instead of -EFAULT.
Signed-off-by: Wei Yongjun <yjwei@cn.fujitsu.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
The ioctl KVM_IA64_VCPU_GET_STACK does not set the error code if
copy_to_user() fail, and 0 will be return, we should use -EFAULT
instead of 0 in this case, so this patch fixed it.
Signed-off-by: Wei Yongjun <yjwei@cn.fujitsu.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
This patch use generic linux function native_store_idt()
instead of kvm_get_idt(), and also removed the useless
function kvm_get_idt().
Signed-off-by: Wei Yongjun <yjwei@cn.fujitsu.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
Reading rip is expensive on vmx, so move it inside the tracepoint so we only
incur the cost if tracing is enabled.
Signed-off-by: Avi Kivity <avi@redhat.com>
The prep_new_page() in page allocator calls set_page_private(page, 0).
So we don't need to reinitialize private of page.
Signed-off-by: Minchan Kim <minchan.kim@gmail.com>
Cc: Avi Kivity<avi@redhat.com>
Signed-off-by: Avi Kivity <avi@redhat.com>
This patch does:
- no need call tracepoint_synchronize_unregister() when kvm module
is unloaded since ftrace can handle it
- cleanup ftrace's macro
Signed-off-by: Xiao Guangrong <xiaoguangrong@cn.fujitsu.com>
Signed-off-by: Avi Kivity <avi@redhat.com>
If fail to create the vcpu, we should not create the debugfs
for it.
Signed-off-by: Wei Yongjun <yjwei@cn.fujitsu.com>
Acked-by: Alexander Graf <agraf@suse.de>
Cc: stable@kernel.org
Signed-off-by: Avi Kivity <avi@redhat.com>
This patch fixed possible memory leak in kvm_arch_vcpu_create()
under s390, which would happen when kvm_arch_vcpu_create() fails.
Signed-off-by: Wei Yongjun <yjwei@cn.fujitsu.com>
Acked-by: Carsten Otte <cotte@de.ibm.com>
Cc: stable@kernel.org
Signed-off-by: Avi Kivity <avi@redhat.com>
LMSW is present in both group tables. It was marked privileged only in
one of them. Intel analog of VMMCALL is already marked privileged.
Signed-off-by: Gleb Natapov <gleb@redhat.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
These bits are ignored by the hardware too. Implement this
for nested svm too.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
This patch adds the correct handling of the nested io
permission bitmap. Old behavior was to not lookup the port
in the iopm but only reinject an io intercept to the guest.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
There is a generic function now to calculate msrpm offsets.
Use that function in nested_svm_exit_handled_msr() remove
the duplicate logic (which had a bug anyway).
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
This patch optimizes the way the msrpm of the host and the
guest are merged. The old code merged the 2 msrpm pages
completly. This code needed to touch 24kb of memory for that
operation. The optimized variant this patch introduces
merges only the parts where the host msrpm may contain zero
bits. This reduces the amount of memory which is touched to
48 bytes.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
