android_kernel_samsung_msm8976/drivers/fingerprint/et320.h

225 lines
6.1 KiB
C

/*
* Copyright (C) 2013 Samsung Electronics. All rights reserved.
*
* This program is free software; you can redistribute it and/or
* modify it under the terms of the GNU General Public License
* version 2 as published by the Free Software Foundation.
*
* This program is distributed in the hope that it will be useful, but
* WITHOUT ANY WARRANTY; without even the implied warranty of
* MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the GNU
* General Public License for more details.
*
* You should have received a copy of the GNU General Public License
* along with this program; if not, write to the Free Software
* Foundation, Inc., 51 Franklin St, Fifth Floor, Boston, MA
* 02110-1301 USA
*/
#ifndef _ET320_LINUX_DIRVER_H_
#define _ET320_LINUX_DIRVER_H_
#ifdef ENABLE_SENSORS_FPRINT_SECURE
#define FEATURE_SPI_WAKELOCK
#endif /* CONFIG_SEC_FACTORY */
#include <linux/module.h>
#include <linux/spi/spi.h>
#ifdef ENABLE_SENSORS_FPRINT_SECURE
#include <linux/wakelock.h>
#include <linux/clk.h>
#include <linux/pm_runtime.h>
#include <linux/spi/spidev.h>
#include <linux/of.h>
#include <linux/of_device.h>
#include <linux/of_dma.h>
#include <linux/amba/bus.h>
#include <linux/amba/pl330.h>
#include <linux/cpufreq.h>
#endif
/*#define ET320_SPI_DEBUG*/
#ifdef ET320_SPI_DEBUG
#define DEBUG_PRINT(fmt, args...) pr_err(fmt, ## args)
#else
#define DEBUG_PRINT(fmt, args...)
#endif
#define VENDOR "EGISTEC"
#define CHIP_ID "ET320"
/* assigned */
#define ET320_MAJOR 153
/* ... up to 256 */
#define N_SPI_MINORS 32
#define ET320_ADDRESS_0 0x00
#define ET320_WRITE_ADDRESS 0xAC
#define ET320_READ_DATA 0xAF
#define ET320_WRITE_DATA 0xAE
#define FP_EEPROM_WREN_OP 0x06
#define FP_EEPROM_WRDI_OP 0x04
#define FP_EEPROM_RDSR_OP 0x05
#define FP_EEPROM_WRSR_OP 0x01
#define FP_EEPROM_READ_OP 0x03
#define FP_EEPROM_WRITE_OP 0x02
#define BITS_PER_WORD 8
#define SLOW_BAUD_RATE 16000000
#define DRDY_IRQ_ENABLE 1
#define DRDY_IRQ_DISABLE 0
#define ET320_INT_DETECTION_PERIOD 10
#define ET320_DETECTION_THRESHOLD 10
#define FP_REGISTER_READ 0x01
#define FP_REGISTER_WRITE 0x02
#define FP_GET_ONE_IMG 0x03
#define FP_SENSOR_RESET 0x04
#define FP_POWER_CONTROL 0x05
#define FP_SET_SPI_CLOCK 0x06
#define FP_RESET_SET 0x07
#ifdef ENABLE_SENSORS_FPRINT_SECURE
#define FP_DIABLE_SPI_CLOCK 0x10
#define FP_CPU_SPEEDUP 0x11
#define FP_SET_SENSOR_TYPE 0x14
/* Do not use ioctl number 0x15 */
#define FP_SET_LOCKSCREEN 0x16
#define FP_SET_WAKE_UP_SIGNAL 0x17
#endif
#define FP_POWER_CONTROL_ET510 0x18
#define FP_IOCTL_RESERVED_01 0x19
#define FP_EEPROM_WREN 0x90
#define FP_EEPROM_WRDI 0x91
#define FP_EEPROM_RDSR 0x92
#define FP_EEPROM_WRSR 0x93
#define FP_EEPROM_READ 0x94
#define FP_EEPROM_WRITE 0x95
/* trigger signal initial routine */
#define INT_TRIGGER_INIT 0xa4
/* trigger signal close routine */
#define INT_TRIGGER_CLOSE 0xa5
/* read trigger status */
#define INT_TRIGGER_READ 0xa6
/* polling trigger status */
#define INT_TRIGGER_POLLING 0xa7
/* polling abort */
#define INT_TRIGGER_ABORT 0xa8
/* Sensor Registers */
#define FDATA_ET320_ADDR 0x00
#define FSTATUS_ET320_ADDR 0x01
/* Detect Define */
#define FRAME_READY_MASK 0x01
struct egis_ioc_transfer {
u8 *tx_buf;
u8 *rx_buf;
__u32 len;
__u32 speed_hz;
__u16 delay_usecs;
__u8 bits_per_word;
__u8 cs_change;
__u8 opcode;
__u8 pad[3];
};
#define EGIS_IOC_MAGIC 'k'
#define EGIS_MSGSIZE(N) \
((((N)*(sizeof(struct egis_ioc_transfer))) < (1 << _IOC_SIZEBITS)) \
? ((N)*(sizeof(struct egis_ioc_transfer))) : 0)
#define EGIS_IOC_MESSAGE(N) _IOW(EGIS_IOC_MAGIC, 0, char[EGIS_MSGSIZE(N)])
struct etspi_data {
dev_t devt;
spinlock_t spi_lock;
struct spi_device *spi;
struct list_head device_entry;
/* buffer is NULL unless this device is open (users > 0) */
struct mutex buf_lock;
unsigned users;
u8 *buffer;
unsigned int ocp_en; /* ocp enable GPIO pin number */
unsigned int drdyPin; /* DRDY GPIO pin number */
unsigned int sleepPin; /* Sleep GPIO pin number */
unsigned int ldo_pin; /* Ldo GPIO pin number */
unsigned int ldo_pin2; /* Ldo2 GPIO pin number */
unsigned int min_cpufreq_limit;
unsigned int spi_cs; /* spi cs pin <temporary gpio setting> */
unsigned int drdy_irq_flag; /* irq flag */
bool ldo_onoff;
/* For polling interrupt */
int int_count;
struct timer_list timer;
struct work_struct work_debug;
struct workqueue_struct *wq_dbg;
struct timer_list dbg_timer;
int sensortype;
#ifdef CONFIG_SENSORS_FINGERPRINT_SYSFS
struct device *fp_device;
#endif
#ifdef ENABLE_SENSORS_FPRINT_SECURE
bool enabled_clk;
bool isGpio_cfgDone;
#ifdef FEATURE_SPI_WAKELOCK
struct wake_lock fp_spi_lock;
#endif
struct task_struct *t;
int user_pid;
int signal_id;
#endif
bool tz_mode;
int detect_period;
int detect_threshold;
bool finger_on;
};
#ifdef ENABLE_SENSORS_FPRINT_SECURE
/*
* Used by IOCTL command:
* ETSPI_IOCTL_REGISTER_LOCK_SCREEN_WAKE_UP_SIGNAL
*
* @user_pid:Process ID to which SPI driver sends signal indicating that LOCK SCREEN
* is asserted
* @signal_id:signal_id
*/
struct etspi_ioctl_register_signal {
int user_pid;
int signal_id;
};
#endif
int etspi_io_read_register(struct etspi_data *etspi, u8 *addr, u8 *buf);
int etspi_io_write_register(struct etspi_data *etspi, u8 *buf);
int etspi_io_get_one_image(struct etspi_data *etspi, u8 *buf, u8 *image_buf);
int etspi_read_register(struct etspi_data *etspi, u8 addr, u8 *buf);
int etspi_mass_read(struct etspi_data *etspi, u8 addr, u8 *buf, int read_len);
int etspi_eeprom_wren(struct etspi_data *etspi);
int etspi_eeprom_wrdi(struct etspi_data *etspi);
int etspi_eeprom_rdsr(struct etspi_data *etspi, u8 *buf);
int etspi_eeprom_wrsr(struct etspi_data *etspi, u8 *buf);
int etspi_eeprom_read(struct etspi_data *etspi,
u8 *addr, u8 *buf, int read_len);
int etspi_eeprom_write(struct etspi_data *etspi, u8 *buf, int write_len);
#ifdef CONFIG_SENSORS_FINGERPRINT_SYSFS
extern int fingerprint_register(struct device *dev, void *drvdata,
struct device_attribute *attributes[], char *name);
extern void fingerprint_unregister(struct device *dev,
struct device_attribute *attributes[]);
#endif
#endif