85c05bd10c
For auto resonance detection to work properly, sufficient back-emf has to be generated. In general, back-emf takes some time to build up. When the auto resonance mode is chosen as QWD, high-z will be applied for every LRA cycle and hence there won't be enough back-emf at the start-up. Hence, the motor needs to vibrate for few LRA cycles after the PLAY bit is asserted. So disable the auto resonance and enable it back after some delay. Add a DT property to configure this delay value. CRs-Fixed: 833062 Change-Id: I688329f642ca9d506e203f448da5d874b91b77ff Signed-off-by: Abinaya P <abinayap@codeaurora.org> |
||
---|---|---|
.. | ||
avtimer.txt | ||
ipa.txt | ||
qca1530.txt | ||
qpnp-clkdiv.txt | ||
qpnp-coincell.txt | ||
qpnp-haptic.txt | ||
qpnp-power-on.txt | ||
qpnp-revid.txt | ||
qpnp-usbdetect.txt | ||
qpnp-vibrator.txt | ||
rmnet_ipa.txt | ||
spss.txt | ||
ssm.txt | ||
uim_hs_lite.txt | ||
usb-bam.txt |